STMicroelectronics Nucleo Pack MCU Development Kit P-NUCLEO-IOM01M1

STEVAL-IOM001V1
IO-Link master PHY based on L6360
Interrupt diagnostics pin
I²C and UART interface
SPI (slave) interface
65 mA selectable (3.3 or 5.0 V) linear regulator
CQ (push-pull) and L+ (high side) switches
IQ additional IEC61131-2 type 1 digital input
L+ and CQ overload and overheating protections with non-dissipative cut-off function
QFN-26L (3.5x5x1 mm) package
Operating voltage range from 18 to 32.5 V
Additional high side switch for L+ heavy loads
LEDs for status and diagnostics
Ground and VCC wire break protections
Equipped with ST morpho connectors
32-bit Micro-controller based on ARM®Cortex®-M4 core (180 MHz max.) with 512-Kbyte Flash memory and 128 (+4) Kbyte RAM
Two types of extension resources: Arduino™ UNO Revision 3 connectivity and ST morpho extension pin headers for full access to all STM32 I/Os
Mbed-enabled
On-board ST-LINK/V2-1 debugger/programmer with SWD connector: selection-mode switch to use the kit as a standalone ST-LINK/V2-1
Two push-buttons: USER and RESET

For products that are Customized and under Non-cancellable & Non-returnable, Sales & Conditions apply.