Xilinx HW-USB-II-G Platform Cable USB II Development Kit

Platform Cable USB II configures Xilinx FPGAs, programs Xilinx PROMs and CPLDs and directly programs third-party SPI Flash memory devices.

Programs and configures all Xilinx devices:
XC18V00 ISP PROMs
Platform Flash XCF00S/XCF00P/XL PROMs
All UltraScale, 7 series, Virtex and Spartan FPGA families
All Zynq-7000 AP Systems-on-Chip
XC9500XL and CoolRunner XPLA3/CoolRunner-II CPLDs
Supports JTAG and Slave-Serial programming topologies
Firmware downloadable over cable
Fully integrated and optimised for use with Xilinx iMPACT software (required for programming and configuration)
Intuitive multiple cable management from a single application
Compatible with Windows and Linux operating systems
Automatically senses and adapts to target I/O voltage
Interfaces to devices operating at +5 V (TTL), +3.3 V (LVCMOS), +2.5 V, +1.8 V and +1.5 V
Powered from USB connection
Target power status LED
Firmware updates are transparent to the user
Highly optimised for use with Xilinx design tools: ISE Foundation Software, Embedded Development Kit, ChipScope Pro Analyser and System Generator for DSP

The Xilinx platform cable USB II Development Kit is more than just a simple USB cable. It provides integrated firmware (hardware and software) to deliver high-performance, reliable, and easy to perform configuration of Xilinx devices. It attaches to user hardware for configuring Xilinx FPGAs, programming Xilinx PROMs and CPLDs, and directly programming third-party SPI flash devices. Also, the cable provides a means of indirectly programming platform flash XL, third party SPI flash memory devices, and third-party parallel NOR flash memory devices via the FPGA JTAG port.

•
High-performance FPGA and PROM programming and configuration
• Includes innovative FPGA-based acceleration firmware encapsulated in a small form factor pod attached to the cable
• Leverages high-speed slave-serial mode programming interface
• Fully integrated and optimized for use with Xilinx iMPACT software
• Intuitive multiple cable management from a single application
• Easy to use
• Intuitive multiple cable management from a single application
• Automatically senses and adapts to target I/O voltage
• Interfaces to devices operating at 5V (TTL), 3.3V (LVCMOS), 2.5V, 1.8V and 1.5V
• Intuitive flyleads-to-cable interface labelling

•
CE certified
• FCC certified
• IEEE 1149.1

Programmable Logic Programming