Cypress Semiconductor CYPD2703-09FNXIT, USB Controller, USB, 2.7 → 5.5 V, 9-Pin CSP

Technical data sheets
Legislation and Compliance
RoHS Certificate of Compliance
Product Details

EZ-PD™ CMG1 is a dedicated USB Type-C EMCA controller. EZ-PD CMG1 integrates a complete Type-C transceiver including the RA termination resistors on the VCONN pins and VBUS short circuit protection on both VCONN and CC pins. CMG1 also includes 40 bytes of storage for configuration of vendor-, device-, and cable-specific configuration data.EZ-PD CMG1 is targeted for passive EMCA implementations with either one or two e-marker chips on the cable.

Type-C Support and USB-PD Support
Supports USB PD3.0 spec and USB Type-C spec version 1.3(Including support for the revised minimum VCONN operating voltage of 3 V)
Integrated high-voltage protection on CC, VCONN1, and VCONN2 pins to protect against accidental shorts to the VBUS pin on the Type-C connector
40-byte storage programmable over Type-C interface forstoring vendor-, device-, and cable-specific configuration data
Termination resistor RA on VCONN1 and VCONN2
Supports RA weakening to reduce power consumption
Supports electronically marked passive cable implementations with one or two controllers

Attribute Value
Number of Transceivers 1
Protocols Supported USB
Power Supply Type Single
ESD Protection Yes
Typical Single Supply Voltage 2.7 → 5.5 V
Mounting Type Surface Mount
Package Type CSP
Pin Count 9
Dimensions 1.35 x 1.37 x 0.27mm
Height 0.27mm
Length 1.35mm
Maximum Operating Temperature +85 °C
Minimum Operating Temperature -40 °C
Width 1.37mm
Stock check temporarily unavailable - call for stock availability
Price Each (In a Pack of 6)
SGD 2.34
(exc. GST)
SGD 2.50
(inc. GST)
Per unit
Per Pack*
6 - 54
60 - 144
150 - 294
300 - 594
600 +
*price indicative
Packaging Options:
Related Products's professional line of 2-in-1 USB KVM switch ...
Description:'s professional line of 2-in-1 USB KVM switch cables are specifically designed to work with your StarView or Server Remote Control KVM switch, integrating the necessary USB and VGA connections into a single cable - reducing tangles while maintaining excellent ...
The FTDI Chip FT232R is a USB to ...
The FTDI Chip FT232R is a USB to serial UART interface with optional clock generator output. Asynchronous and synchronous bit bang interface modes are also available. Together with EEPROM, clock circuit and USB resistors effectively makes it a "3 in ...
USB is a cable bus supporting data exchange ...
USB is a cable bus supporting data exchange between a host computer and a wide range of simultaneously accessible peripherals. There is a differential signal data interface for transmit and receive communication path. The bus includes power at 5 Volts. ...
The FT245B and FT245R are USB to parallel ...
The FT245B and FT245R are USB to parallel FIFO converter interfaces. Single chip USB to parallel FIFO bidirectional data transfer interfaceEntire USB protocol handled on the chip - No USB-specific firmware programming requiredFT245B USB compatibleFT245R USB 2.0 Full Speed compatibleFT245R ...