Adafruit 2895 FeatherWing Non-Latching Relay for Adafruit Feather
- RS Stock No.:
- Mfr. Part No.:
- ADAFRUIT INDUSTRIES
|1 - 4||SGD10.65|
|5 - 9||SGD10.33|
Adafruit Non-Latching Mini Relay FeatherWing
FeatherWings add specific functionality to your Feather development board. They fit directly on top of your Feather using stacking header pins.
The non-latching mini relay FeatherWing gives you control over power so you can now turn on and off various devices including lamps, fans, solenoids. In fact, you can switch power for many small appliances that run on up to 250 V ac but you need check the amount of power – 60 W or less.
The non-latching relay, requires a single control pin, the SET pin. When set to high, the relay switches and a red LED lights. If power is lost then the relay will go back open.
In terms of how much power, you can switch up to 2A of resistive current at up to 30 V dc or 40 V ac. At 110 V dc, switch up to 0.3A, at 120 V ac up to 0.5 A, and at 250 V ac you can switch up to 0.6A. Check the datasheet for more details.
A 3-pin terminal block is supplied with this FeatherWing to wire it up with the device you are controlling and some light soldering is required.
A Latching Relay FeatherWing is also available (RS 124-5527) but requires two signal pins.
50.8 x 22.9 x 11.4 mm / 2" x 0.9" x 0.45"
Weight: 5.3 g
If using with high voltages of more than 24 V, use care and common sense. High voltages require experience, and are only for use by engineers who are comfortable with guidelines and know how to use it safely.
Adafruit FeatherWing Add-On Boards
|Power Management Function||Non-Latching Relay|
|Kit Classification||Development Board|
|For Use With||Adafruit Feather|