- RS Stock No.:
- 536-3671
- Mfr. Part No.:
- 250-12-UK0-T195-BX1-RS
- Manufacturer:
- Power Adhesives
Discontinued product
Alternatives
This product is not currently available. Here are our alternative recommendations.
- RS Stock No.:
- 536-3671
- Mfr. Part No.:
- 250-12-UK0-T195-BX1-RS
- Manufacturer:
- Power Adhesives
Technical data sheets
Legislation and Compliance
Product Details
Lightweight Hot Melt Gun
Applicator gun accepts RS 12mm hot melt adhesive sticks only. The gun features:
Trigger feed operation, allowing one hand operation.
Silicone inlet sleeve.
1.5m of double insulated lead.
Ready for use 8 minutes after connection to the mains.
Typical operating temperature of 206°C.
Unused sticks may be left in the gun indefinitely.
Produces a thin bead of hot adhesive.
Suitable for use from 100 to 250 V a.c. supply.
UK (BS1363) and Australian plug versions available.
Maximum power consumption 45W
Power on warning light
Silicone inlet sleeve.
1.5m of double insulated lead.
Ready for use 8 minutes after connection to the mains.
Typical operating temperature of 206°C.
Unused sticks may be left in the gun indefinitely.
Produces a thin bead of hot adhesive.
Suitable for use from 100 to 250 V a.c. supply.
UK (BS1363) and Australian plug versions available.
Maximum power consumption 45W
Power on warning light
Typical uses:
Temporary bonding on PCBs.
Speaker cone/grille fixing.
Coil termination and trunking installation.
Speaker cone/grille fixing.
Coil termination and trunking installation.
Note
It is recommended that the gun is disconnected from the supply if the delay before use is likely to exceed 30 minutes.
Warning
The melted adhesive reaches temperature up to 200°C
Specifications
Attribute | Value |
---|---|
Type | Hot Melt |
Glue Stick Size | 11 <arrow/> 12mm |
Heavy Duty | Yes |
Cord Type | Corded |
Model | Tec250 |
Flow Rate | 750g/h |
Heater Power | 500W |
Voltage Rating | 100 → 240V ac |