Sensata/Cynergy 3 RSF50 Series Vertical Nylon Float Switch, Float, 1m Cable, NO/NC, 240V ac Max, 120V dc Max

The RSF50 series of compact vertical float switches have a single switching point, mounting is either from the top or bottom of the tank therefore access to the inside of the tank is required. These float switches are ideal for vending machine, printing systems, and chemical dosing applications.

Manufactured in a variety of materials with a choice of gasket materials to suit most commonly used liquids
Mounting in top or bottom of tank
N/O versions can be configured as N/C by float inversion
All units WRAS approved for use in hot and cold water

Part numbers ending in '1/8' have a 1/8"NPT mounting thread
Part numbers ending in 'C' have an M12 mounting thread

The cable entry point must NOT under any circumstances be submerged.
On the Horizontal switches they must be fitted through the wall of a tank so that the cable is on the outside.
On the Vertical type the mounting thread and cable entry must be above the highest level of the liquid.

epoxy sealed leadouts

Choose this sensitive vertical float switch from Sensata Cynergy3 to monitor liquid levels in your tanks. It's mounted either at the top or bottom of the tank from the inside, so it's a good choice for when there's no side access to a tank. This switch is made of a nylon material that's lightweight and waterproof, so it can withstand long-term exposure to liquids. Its nitrile gasket offers excellent abrasion resistance to stand up to wear and tear. You'll find this type of switch used in modern dishwater systems and water closets.

• Low current consumption rate of 600mA (milliamperes) for energy efficiency
• Cable length of 1m for flexible connections
• Wide operating temperature range of -20°C to +75°C for use in harsh environments

It's important not to submerge the cable entry points of this float switch to avoid electrical hazards. If you're mounting the switch horizontally, you must fit it through the wall of the tank so the cable is outside. For vertical installations, the switch's mounting thread and cable entry points must be above the liquid level.