SEGGER JTAG Isolator

  • RS Stock No. 131-1335
  • Mfr. Part No. 8.07.00 JTAG Isolator
  • Manufacturer SEGGER
Technical data sheets
Legislation and Compliance
RoHS Certificate of Compliance
Product Details

J-Link ARM JTAG Isolator Board

The J-Link JTAG Isolator can be connected between a J-Link Probe and an ARM-board with a 20-pin JTAG-ARM connector to provide electrical isolation. This is essential when the development tools are not connected to the same ground as the application.

Compatible Probes

J-Link BASE, J-Link PRO, J-Link ULTRA+, J-Link PLUS , Flasher Portable, Flasher ARM

Features

• 1kV DC optical isolation
• +3.3V and +5Vdc target operation supported
• Powered from probe and target
• JTAG 20-pin connection with TRST, TDI, TMS, TCK, RTCK, TDO and RESET signals
• Power consumption on target side: 35mA typical
• JTAG frequency: Up to 4MHz
• 3 x LEDs: Probe Power, Target Power and Target RESET

Specifications
Attribute Value
For Use With J-Link Probes
3 In stock for delivery within 3 working days
Price Each
SGD 452.00
(exc. GST)
SGD 483.64
(inc. GST)
units
Per unit
1 +
SGD452.00
Related Products
J-Link ULTRA+ is a JTAG/SWD programming and debug ...
Description:
J-Link ULTRA+ is a JTAG/SWD programming and debug probe supporting a large number of processor cores. It features seamless integration into the IAR Embedded Workbench IDE and comes with integrated licenses for unlimited breakpoints in Flash memory, RDI / RDDI ...
J-Trace PRO for Cortex-M enables continuous streaming trace ...
Description:
J-Trace PRO for Cortex-M enables continuous streaming trace via its Gigabit Ethernet interface, lifting the limitations of internal buffers and slow data transmission. J-Trace PRO can capture complete traces over long periods - thereby enabling the recording of infrequent, hard-to-reproduce ...
The JTAG-HS3 programming cable allows high-speed programming/debugging of ...
Description:
The JTAG-HS3 programming cable allows high-speed programming/debugging of Xilinx FPGA and SoC devices from a host PC. • Separate Vref drives JTAG signal voltages• Vref can be any voltage between +1.8V and +5V• USB 2.0 HS port drives JTAG bus ...
Reduced form factor ARM/Cortex Debug Probe, Microchip PIC32 ...
Description:
Reduced form factor ARM/Cortex Debug Probe, Microchip PIC32 Debug Probe, Renesas RX Debug Probe, and SiLabs EFM8 / C8051 Debug Probe. Includes a USB cable, and a 20-pin, 0.1" ribbon cable. Additional adapters (Sold Separately) as required by the target ...